| –
| Remove clutch release lever -1- together with release bearing -2- and retaining spring -3-. |
| –
| Remove bolts -4- and detach retaining piece -5- (if fitted) with guide sleeve -6-. |
| –
| Remove any existing grease on clutch release lever -1-, release bearing -2- and guide sleeve -6-. |
| –
| Clean guide sleeve -6- and install together with retaining piece -5- (if previously fitted). |
Note | The retaining piece -5- is omitted if a new guide sleeve -6- is installed. |
| –
| Clean threads of bolts -4- with wire brush. Then apply locking fluid -AMV 185 101 A1- to bolts and tighten. Tightening torque → Item |
Caution | Grating/creaking noises can occur when clutch is operated. |
| Grease bearing surfaces for clutch release lever with lubricating paste -G 000 150- → Item. |
|
| –
| Engage release bearing -2- and retaining spring -3- in release lever -1- and install complete assembly. |
|
|
|
