Audi Workshop Service and Repair Manuals

Removing and installing coolant pump Special tools and workshop equipment required

t  Pin wrench -3212-

Removing –  Drain coolant → Chapter. –  Remove intake manifold (top section) → Rep. gr.23. –  Remove pump for exhaust gas recirculation cooler -V400- with bracket → Chapter. –  Remove poly V-belt → Chapter.

–  Engine codes CAMA, CAMB, CCLA, CCWA, CCWB, CGKA, CGKB: pivot toothed belt cover forwards -arrows- and disengage retaining pegs on underside of toothed belt cover.

–  Engine code CAPA: release clamps -arrows-, pivot toothed belt cover forwards and disengage retaining pegs on underside of toothed belt cover.

–  Remove bolts for coolant pump pulley -arrows- (counterhold with pin wrench -3212-).

–  Remove bolts and detach coolant pump -arrow-. Installing Installation is carried out in the reverse order; note the following: –  Clean sealing surface. –  Tighten coolant pump bolts → Fig.. –  Install poly V-belt → Chapter. –  Install pump for exhaust gas recirculation cooler -V400- with bracket → Chapter. –  Install intake manifold (top section) → Rep. gr.23. –  Fill up with coolant → Anchor.