Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing crankshaft oil seal (gearbox end) >
< Removing and installing drive plate
A4 Mk3
Power unit
6-cylinder TDI engine (2.7 ltr.; 3.0 ltr. 4-valve common rail), mechanics
Enginecrankshaft group, pistons
Cylinder block (gearbox end)
Removing and installing needle bearing in drive plate
Removing and installing needle bearing in drive plate
Removing and installing needle bearing in drive plate
Special tools and workshop equipment required
t
Tube -VW 418 A-
t
Tube -VW 421-
t
Support -40 - 103-
Procedure
l
Gearbox removed.
–
Remove drive plate
→ Chapter
.
–
Place support -40 - 103- under drive plate when pressing out and pressing in needle bearing.
–
Use tube -VW 421- and workshop press and press out needle bearing.
l
Smaller diameter of tube -VW 421- faces drive plate.
–
Carefully press in needle bearing as far as stop, using tube -VW 418 A- and workshop press.
l
Installation position: closed side of needle bearing faces engine.
–
Install drive plate
→ Chapter
.
Power unit
6-cylinder TDI engine (2.7 ltr.; 3.0 ltr. 4-valve common rail), mechanics
Enginecrankshaft group, pistons
Cylinder block (gearbox end)
Removing and installing needle bearing in drive plate
Renewing crankshaft oil seal (gearbox end) >
< Removing and installing drive plate