audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing headlight dipped beam bulb M29/M31 > < Exploded view of halogen headlight

A4 Mk3

Removing and installing headlight housing
Removing and installing headlight housing
   
Removing
–  Switch off ignition and take out ignition key.
–  Turn light switch to position „0“.
–  Remove lock carrier cover → Rep. gr.63.
–  Unplug electrical connector -2-.
–  Remove bolts -3, 4, 5- at headlight housing -1-.
  A94-10498
–  Pull headlight housing -1- towards front -arrow A- until headlight guides have been guided out of mountings on mounting support.
–  Then swivel headlight housing towards wing end -arrow B- and detach from mounting support.
  A94-10553
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Position outer edge of headlight housing -1- on inside behind wing.
–  Swivel headlight housing inwards -arrow A-; guide rails -2- on headlight housing should engage in guides on mounting -3--arrows-.
–  Slide headlight housing towards rear as far as stop into mounting for headlight housing -arrow B-.
l  Do not use force when inserting headlight housing in mounting for headlight housing and make sure it engages smoothly.
  A94-10499
–  When inserting headlight -4-, make sure that breather -3- for headlight is pushed evenly onto mounting -2- for breather hose -1- in direction of -arrow-.
  A94-10637
–  Tighten bolts -3, 4, 5-.
  A94-10498

Renewing headlight dipped beam bulb M29/M31 > < Exploded view of halogen headlight