audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing left headlight range control motorV48 > < Renewing front side marker light bulb M33/M34

A4 Mk3

Renewing front turn signal bulb M5/M7
Renewing front turn signal bulb -M5-/-M7-
Special tools and workshop equipment required
t  Protective gloves
t  Safety goggles
t  Carpet knife
Removing
–  Remove headlight housing → Chapter.
  Note
t  Before renewing front turn signal bulb, headlight housing must be cut open at specified location with a sharp carpet knife.
t  For subsequent sealing of assembly opening, housing cover is available → Electronic parts catalogue
  WARNING
Risk of injury and damage.
t  Wear protective gloves and safety goggles.
t  To prevent damage to electrical wiring in headlight housing, do not cut too deep.
   
–  Cut dummy cover -2- out of headlight housing using a sharp carpet knife.
–  Detach cover -1- for main beam from headlight housing.
  A94-10602
–  Turn bulb holder -1- anti-clockwise -arrow- and pull it out of housing.
–  Slide holder for turn signal bulb -2- upwards towards opening for main beam light.
–  Unplug electrical connector -3- and take bulb holder out of housing.
  A94-10575
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Insert new bulb holder with bulb into headlight, taking care not to touch glass bulb with bare hands.
–  Close opening in headlight with housing cover -1- from repair kit → Electronic parts catalogue.
–  Tighten bolts -arrows-.
–  Install headlight housing → Chapter.
  A94-10603

Removing and installing left headlight range control motorV48 > < Renewing front side marker light bulb M33/M34