A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
-
Remove retaining clip - 1 - for selector lever cable on shift mechanism downward.
-
Pull plastic securing spring - 2 - slightly to front and push pin - 3 - upward only as far as necessary - arrow -.
‹› Make sure that pin is not pushed fully out.
-
Remove selector lever cable - 4 - from shift mechanism.
‹› Take care not to bend or kink selector lever cable.
Installing
Install in reverse order, paying attention to the following:
‹› Tightening specifications. Refer to => [ Selector Lever Cable and Locking Cable Assembly Overview ] See: Shifter A/T/Service and
Repair/Removal and Replacement/Selector Lever Cable and Locking Cable Assembly Overview and => [ Shift Mechanism Assembly Overview ]
See: Shifter A/T/Service and Repair/Removal and Replacement/Shift Mechanism Assembly Overview.
-
Install new securing clasp - 1 - for selector lever cable to shift mechanism.
‹› Installation position: The angled end of the securing clasp faces toward the inside of the shift mechanism.
-
Insert the end of the selector lever cable - 4 - into the joint of the selector lever.
-
Press pin - 3 - downward - arrow -.
-
Check whether plastic securing spring - 2 - has locked the pin.
-
Bolt lower cover securely to shift mechanism - arrows -.