A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
-
Replace O-rings on wiring harness connector and lightly lubricate with ATF.
-
Clip wiring harness - A - onto the mechatronics unit - B -. At the same time, insert the tab - arrow - on backside of wiring harness into the
mechatronics unit.
‹› If the tab on the backside of the wiring harness breaks off, the wiring harness must be replaced. Refer to => [ Wiring Harness in Transmission ]
See: Wiring Harness/Service and Repair.
-
Insert wiring harness connector into transmission housing.
‹› Installation position: Flat part of rear collar faces downward; tabs on collar are horizontal.
-
Set mechatronics unit in place without using force, and at the same time insert stud of selector lever - arrow - into groove of selector slide - A -; if
necessary, move selector slide back or forth.