A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
8
Clutch pedal
‹› Removing and installing, refer to => [ Clutch Master Cylinder ] See: Clutch Hydraulic System/Clutch Master Cylinder/Service and Repair
9
Circlip
10
Base block
‹› Removing and installing => [ (Item 9) Base block ] See: Clutch Hydraulic System/Service and Repair/Removal and Replacement
11
Internal hex bolt - 20 Nm
12
Clutch master cylinder
‹› Removing and installing, refer to => [ Clutch Master Cylinder ] See: Clutch Hydraulic System/Clutch Master Cylinder/Service and Repair
‹› Gasket - arrow - must not be removed
13
Over-center spring
‹› Black side faces toward clutch pedal
‹› Removing and installing, refer to => [ Over-Center Spring ] See: Over-Center Spring
14
Clutch Pedal Starter Interlock Switch (F194)
‹› Vehicles with 3.2L FSI engine
‹› Vehicle can only be started with clutch fully depressed ( Clutch Pedal Starter Interlock Switch).
‹› May be installed just one time; must be replaced when removed
‹› Removing and installing, refer to => [ Clutch Pedal Starter Interlock Switch ] See: Clutch Switch/Service and Repair/Clutch Pedal Starter
Interlock Switch
15
Torx(R) bolt - 25 Nm
‹› For securing master brake cylinder/brake booster on mounting bracket