A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
Constant Velocity Joint: Overhaul
Triple Roller Joint AAR 2600 i or 3300 i, Disassembling
Triple Roller Joint AAR 2600 i or 3300 i, Disassembling
Special tools, testers and auxiliary items required
‹› Thrust Plate (VW 401)
‹› Thrust Plate (VW 402)
‹› Punch (VW 408 A)
‹› Punch (VW 411)
‹› Sleeve (VW 416 B)
‹› Thrust Pad (VW 447 H)
‹› Cv Joint Boot Clamp Tool (V.A.G 1682)
‹› Hose Clamp Pliers (V.A.G 1275)
‹› Torque Wrench (V.A.G 1331)
‹› Torque Wrench (V.A.G 1332)
‹› Assembly Tool (T10065)
‹› Slide Hammer - Complete Set (VW 771)
‹› Assembly device (T40018) for triple roller joint AAR 3300 i
‹› or assembly device (T40084) for triple roller joint AAR 2600 i
Removal
-
Clamp driveshaft horizontally in vise.
‹› Use protective vise covers.
‹› Make sure that drive axle is not damaged.
-
Mark location of joint to drive axle
If they are not marked and are not re-installed in their previously installed positions, noises may occur later during driving operation.
A water-proof felt pen is well-suited for marking.
-
Open clamps - arrows -.