A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
‹› Replace the seals and O-rings.
-
Install selector shaft.
‹› Installation position: Flattened part of selector shaft - B - faces downward.
‹› Ignore - A - and - C -.
-
Slide the selector shaft - 2 - into transmission all the way and install the bolt - 3 -.
‹› Installation position: The groove - arrow - on the bolt - 3 - faces the selector shaft cover.
-
Clean locking bolt threads - 1 - with a wire brush. Then insert bolts with Locking Compound (AMV 185 101 A1 ) and tighten to 45 Nm.
-
Install the cover - A - with an O-ring.