A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1984004.png)
quantity of new high temperature grease G 000 633.
^
Note the installation position of the drive shaft: The central constant velocity joint is located behind the center bearing facing toward the rear final
drive.
^
After removing the drive shaft from the rear final drive, a thick washer that may be located between the shim and the bolt head must not be
reinstalled.
^
It is essential that the locking fluid remaining in the threads in the flange shafts on the transmission and rear final drive is cleaned out after
removing the drive shaft. Otherwise there is a danger that the new bolts will seize when they are screwed in and then shear if they have to removed
later.
^
The threaded holes can be cleaned with a thread tap.
^
Replace drive shaft bolts (self-locking).
-
Install drive shaft and attach bolts for constant velocity joint.
-
Screw in securing bolts -arrows- for center bearing hand-tight.
-
Screw in bolt -3- M10 x 100 into rear final drive.
-
To tighten bolts -1- of the rear and front drive shaft, counterhold with an assembly lever -2-.
-
Remove assembly device 3139
-
Remove securing bolts -arrows- for the center bearing. The drive shaft must be supported manually by a second mechanic.
Note:
^
When removing the securing bolts support the drive shaft by hand.
