A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
The illustration shows a hydraulic bonded rubber bushing. On a conventional bonded rubber bushing, the recesses on the rubber shoulders are turned
90°.
‹› After replacing the bearing, fix any paint damage on the subframe with corrosion protection, primer and black top coat.
Further installation is in the reverse sequence to removal.
Replace the rear bonded rubber bushing or the rear hydraulic bonded rubber bushing.
Applies to all
-
Loosen the nuts on both rear muffler brackets but only as far as to where the thread begins.
-
Place (V.A.G 1383 A) with ( V.A.G 1359/2) - 1 - under the subframe.
-
Place a wood block - 2 - under the subframe - 1 -.
-
Remove the rear subframe bolts => [ (Item 13) Bolt, 115 Nm +90° ].