A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-147001.png)
Suspension Control Module: Service and Repair
Electronic Damping Control Module
Electronic Damping Control Module
Removing
The electronic damping control module (J250) is located behind the right luggage compartment side trim panel.
-
Switch off all electrical consumers.
-
Remove the ignition key.
-
Remove the cover from the right luggage compartment storage compartment.
-
Release and remove the connector - 3 -.
-
Press the clips - 2 - to the side and remove the electronically controlled damping control module - 1 -.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Re-adapt the electronic damping control module. Refer to => [ Control Position, Programing with VAS 5051B ] See: Steering and
Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection..
