A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
‹› For the exact assignment of the driver side A-pillar 6-pin connector station, see the applicable wiring diagram.
Installing
Install in reverse order of removal, observing the following:
-
Install interior CAN cut-off connector (T46i) mount => [ Interior CAN Cut-Off Connector Mount ] See: Powertrain Management/Computers and
Control Systems/Information Bus/Service and Repair/Interior CAN Cut-Off Connector Mount.
-
Connect the airbag electrical connector - 1 - Removal and Installation.
-
Install lower left A-pillar trim.
-
Connect battery. Required actions => [ ] See: Battery/Service and Repair/Removal and Replacement/Battery.