A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
‹› Removing and installing, refer to => [ Rear Final Drive ] See: Differential Assembly/Service and Repair/Rear Final Drive 0BC
(0B4A,0B2A,0B6A,0B5A Transmission)/Rear Final Drive
2
Gasket
‹› Clean the flange shaft and position the gasket
3
Driveshaft
‹› Removing and installing, refer to => [ Driveshaft ] See: Driveshaft
4
Balance disc
‹› Not fitted on all vehicles
‹› May be installed between the multi-point socket bolt => [ (Item 5) Bolt ] and the backing plate => [ (Item 6) Lock plate ] on the rear final
drive.
‹› If installed, balance disc must not be re-installed when propshaft has been detached from rear final drive.
5
Bolt
‹› 30 Nm plus an additional 90° turn
‹› Self-locking
‹› Always replace
‹› Observe tightening sequence => [ Driveshaft tightening sequence: ] See: Driveshaft
‹› The threaded holes for the bolts in the flange shafts must always be cleaned. (e. g. with a thread tap)
‹› for loosening and tightening, use Counterhold Tool (T10172) and Adapters (T10172/5)
6
Lock plate
7
Center bearing
8
Bolt
‹› 20 Nm
9
Transmission