A4 Sedan V6-3.2L (BKH) (2007)
-
Raise window (window is in short lift).
-
Remove rubber stops - arrow -.
-
Loosen front lifting unit lower nut through opening.
-
Slide lifting unit in elongated hole until frame aligns with door inner notch.
-
Tighten front lifting unit and seal opening with rubber plugs.
Tightening torques => [ Window Regulator Assembly Overview ] See: Service and Repair/Front Door Window Regulator Assembly
Overview.
Shaft dimension, checking and adjusting (rear lifting unit)
-
Disengage door trim as shown in illustration.
-
Lay aside door seal - 1 - in B-pillar area.
-
Raise window (window is in short lift).
-
Using a caliper, measure shaft dimension (it must be possible to pull the gap gauge through with firm resistance).
‹› Shaft dimension - a - = 6 mm.
-
Loosen lock nut - arrow -.
-
Adjust shaft dimension by turning threaded pin.
-
Tighten lock nut.
Tightening torques => [ Window Regulator Assembly Overview ] See: Service and Repair/Front Door Window Regulator Assembly
Overview.