A4 Sedan V6-3.2L (BKH) (2007)
/Page-712001.png)
Fluid - CVT: Service and Repair
ATF, Filling For ATF Flushing Process
ATF, filling for ATF flushing process - 01J, Continuously Variable Transmission (CVT)
CAUTION!
^
The Multitronic 01J or 0AN transmission requires a different ATF than shift automatics. Only ATF for CVT transmission which can
be obtained as replacement part must be used.
^
Do not allow engine to run without filling ATF and do not tow the vehicle.
^
Vehicle on a flat surface
Note:
^
The illustration on the reservoir for ATF filler system F/CVT gearbox VAS 5162 in upper left graphic refers to the use of special ATF for
CVT transmissions.
^
The illustration also shows pictures of the steps required to fill the transmission. These steps will be explained in the following.
-
Secure filled reservoir of ATF filler system F/CVT gearbox VAS 5162 as high as possible on the vehicle.
^
The shut-off valve on the ATF filler system F/CVT gearbox VAS 5162 must be closed.
CAUTION!
^
Engine must not be started if only a small amount or no ATF is in the transmission after repair work or after significant ATF loss.
^
In this case, a preliminary filling with 4.5 to 5 liters ATF must be performed.
