A4 Sedan V6-3.2L (BKH) (2007)
/Page-2091002.png)
-
Press in tapered roller bearing outer race for pinion shaft with shim "S4*" (thickness 1.01 mm) into bearing housing.
‹› For measurement purposes a shim "S4" with a thickness of 1.01 mm is inserted provisionally. This is referred to in the following as "S4*". "S4*"
is exchanged with the final shim "S4" after determining measured value "e".
-
Secure transmission housing onto transmission support (VW 353) with bolts - arrows -.
-
Press tapered roller bearing inner race - 1 - onto pinion shaft and secure, refer to => [ Pressing on tapered roller bearing inner race ] See: Service
and Repair/Overhaul/Pinion Shaft
