audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Brake caliper (ceramic brakes) > < Brake hoses and brake lines

A5

Renewing protective caps and guide pins of rear brakes
Renewing protective caps and guide pins of rear brakes
If protective caps or guide pins are damaged, renew using repair kit. Use grease sachet supplied to lubricate guide pins.
Removing
   
–  Remove bolts -1- on brake caliper.
–  Detach brake caliper.
Do not leave brake caliper hanging from brake hose but secure it to bodywork using a suitable cable tie or wire. Take care that brake hose is not damaged by weight of brake components.
  A47-0199
–  Pull protective cap -9- out of groove in brake carrier.
–  Pull guide pin -8- out of brake carrier.
–  Pull protective cap off guide pin.
Installing
–  Grease guide pin before installing.
–  Slide protective cap over groove on guide pin.
  A47-0199
–  Push guide pin -8- with protective cap -9- through brake carrier.
–  Press protective cap over groove on brake carrier.
–  Install brake caliper.
  A47-0199
–  Screw in and tighten bolts -1-.
  A47-0199

Brake caliper (ceramic brakes) > < Brake hoses and brake lines