Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing oil seal for selector shaft >
< Removing and installing gear detector switchF208
A5
Power transmission
6-speed manual gearbox 0B2, four-wheel drive
Gearbox mechanics,operation, construction,diff.
Removing and installing gearbox neutral position senderG701
Removing and installing gearbox neutral position senderG701
Removing and installing gearbox neutral position sender -G701-
l
Only in vehicles with start/stop system
l
Gearbox installed
Removing
–
If fitted, remove rear noise insulation (loosen fasteners
-2-
and
-3-
).
–
Engage 4th gear by shifting gearbox selector lever
-2-
forwards in direction of
-arrow-
.
Note
-Item 1-
can be disregarded.
–
Unplug electrical connector from gearbox neutral position sender -G701-
-1-
.
–
Remove bolt
-arrow-
and pull out gearbox neutral position sender -G701-
-A-
.
Note
Sealing cap
-B-
remains fitted.
Installing
–
Insert gearbox neutral position sender -G701-
-A-
with new O-ring in sealing cap
-B-
for selector shaft.
–
Tighten new bolt
-arrow-
to specified torque
→ Anchor
.
–
Attach connector to gearbox neutral position sender -G701-
-1-
.
–
Install noise insulation
→ Rep. gr.66
.
Tightening torque
Component
Nm
Gearbox neutral position sender -G701-
10 + 45°
l
Renew bolt
Power transmission
6-speed manual gearbox 0B2, four-wheel drive
Gearbox mechanics,operation, construction,diff.
Removing and installing gearbox neutral position senderG701
Renewing oil seal for selector shaft >
< Removing and installing gear detector switchF208