Audi Workshop Service and Repair Manuals > A5 > Power unit | 6-cylinder TDI engine (2.7 ltr.; 3.0 ltr. 4-valve common rail), mechanics | Engine cooling | Coolant pipes | Removing and installing coolant pipe (rear right) - engine codes CCLA, CCWA, CCWB, CGKA, CGKB

Removing and installing coolant pipe (rear right) - engine codes CCLA, CCWA, CCWB, CGKA, CGKB

Special tools and workshop equipment required

t	Hose clip pliers -VAS 6362-

Removing

–	Drain coolant → Chapter.

–	Remove turbocharger → Chapter.

–	Remove bolts -1- and -2- and unplug electrical connector -3- for coolant temperature sender -G62-.

–	Open hose clips -arrows- and detach coolant pipe (rear right) from coolant hoses.

Note

For illustration purposes, the installation position is shown with the engine removed.

Installing

Installation is carried out in the reverse order; note the following:

l	Tightening torque → Chapter „Coolant pipes - exploded view“

Note

Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.

–	Install turbocharger → Chapter.

–	Fill up with coolant → Anchor.

Audi Workshop Service and Repair Manuals