A5
Exploded view of wheel bearing housing, wheel bearing unit, shock absorber for coil springs - four-wheel drive vehicles |
1 - | Drive shaft |
q | Different versions available → Electronic parts catalogue |
2 - | Lock plate |
3 - | Bolt |
q | Tightening torque → Chapter |
4 - | Upper transverse link |
5 - | Nut |
q | 95 Nm |
q | Always renew if removed |
q | Vehicle must be in unladen position when tightening → Chapter |
6 - | Eccentric washer |
7 - | Bolt |
8 - | Bracket |
q | For brake hose, brake caliper wiring harness and wiring harness for rear speed sensor |
9 - | Bolt |
q | 10 Nm |
10 - | Speed sender (rear) |
11 - | Bolt |
q | 9 Nm |
12 - | Bonded rubber bush |
q | Cannot be renewed separately |
13 - | Ball bearing |
Caution
|
q | Removing and installing wheel bearing unit → Chapter |
q | Servicing wheel bearing unit → Chapter |
14 - | Wheel hub |
Caution
|
q | Removing and installing wheel bearing unit → Chapter |
q | Servicing wheel bearing unit → Chapter |
15 - | Splash plate for brakes |
16 - | Bolt |
q | 10 Nm |
17 - | Brake disc |
18 - | Flange bolt |
q | 200 Nm +180° |
q | Always renew if removed |
19 - | Bolt |
q | 5 Nm |
20 - | Track rod |
q | Different versions (aluminium and steel); for correct version, refer to → Electronic parts catalogue |
q | Mixed installation is not permissible |
21 - | Bolt |
q | 90 Nm +90° |
q | Always renew if removed |
q | Vehicle must be in unladen position when tightening → Chapter |
22 - | Bolt |
q | 120 Nm +360° |
q | Always renew if removed |
q | Vehicle must be in unladen position when tightening → Chapter |
Note
Wheel alignment must be checked if bolt is removed. |
23 - | Spacer |
q | Always renew if removed |
24 - | Nut |
q | Always renew if removed |
Caution
|
Note
Wheel alignment must be checked if nut is slackened. |
25 - | Lower transverse link |
26 - | Bonded rubber bush |
q | Renewing → Chapter |
27 - | Wheel bearing housing |
q | Removing and installing → Chapter |
28 - | Bolt |
q | 80 Nm +90° |
q | Always renew if removed |
29 - | Washer |
q | For corrosion protection |
q | Always use |
30 - | Bolt |
q | 150 Nm +180° |
q | Always renew if removed |
q | Vehicle must be in unladen position when tightening → Chapter |
31 - | Shock absorber |
q | Removing and installing → Chapter |
32 - | Protective sleeve |
33 - | Bump stop |
34 - | Bolt |
q | 50 Nm +45° |
q | Always renew if removed |
35 - | Shock absorber mounting (top) |
q | Installation position → Chapter |
36 - | Nut |
q | 35 Nm |
q | Always renew if removed |
37 - | Protective cap |
|