A8 Quattro Sedan V8-4.2L (AKB) (2002)
/Page-1112002.png)
^
Pull out front gear 2 and carefully take out toward top.
Note:
When removing the front gear 2, make sure the sender for transmission output RPM -G195-, which is screwed into the distributor housing,
does not get damaged.
CAUTION!
Gears which have fallen to the floor cannot be re-installed. The transmission must be replaced.
^
Remove snap ring (item -16-,.
A - Support KUKKO 22/1
B - Extractor KUKKO 22/2
Note:
The upper part of the illustration shows how the pulling hooks of the extractor -B- go in the needle bearing.
^
Slide centering sleeve -2- of extractor -B- approximately 4 mm (0.16 inch) in direction of arrow in order to open pulling hooks wide enough.
^
Install extractor-B- in upper lip of front gear 2 and tighten extractor at nut.
^
Set up support -A- on extractor-B- as shown.
^
Support support -A- with pressure plate VW 402 and pretension support using nut-3-.
^
Using standard commercial hot air blower, heat distributor gear on outside, in area of needle bearing seat, quickly to 80 - 100°C (176 - 212°F).
^
Pull needle bearing out quickly.
Installing
The needle bearing is installed in reverse order of removal. In addition, the following work steps have to be carried out.
^
Check sealing ring seat in transmission housing for damage; rework if necessary.
^
Using standard commercial hot air blower, heat distributor gear on outside, in area of needle bearing seat, quickly to 80 - 100°C (176 - 212°F).