A8 Quattro Sedan V8-4.2L (AUX) (2001)
/Page-2200002.png)
-
Measure seat rails length adjustment to motor side and place overlapping seat rail to same dimension.
-
Connect motors for front and rear height adjustment onto driveshaft.
-
Place both seat rails on seat frame and guide guide tabs in holes on seat frame.
-
Measure height adjustment to seat rail front and rear and place overlapping seat rail on same dimension.
-
In this position insert seat frame onto driveshaft - 1 - and at same time guide bolts - 2 - into motor.
-
Measure parallel adjustment again.
-
Tighten seat rail to seat frame with 20 Nm (15 ft.lb.).
-
Securely bolt motor for length adjustment with 10 Nm (7 ft.lb.).
-
Securely bolt motor for height adjustment with 6 Nm (53 in.lb.).
NOTE: To synchronize sender for length adjustment or sender for height adjustment, the total adjustment area from length adjustment, height
adjustment, front as well as height adjustment rear must make a complete run.
