A8 Quattro Sedan V8-4.2L (BGK) (2006)
/Page-3503003.png)
CAUTION!
Replace the circlip with a new one of the same thickness if it is stretched or damaged.
-
Mark the position of the flange/driveshaft - B - to the drive pinion - A - - arrow -.
‹› It is necessary to make this mark so the colored mark - C - on the outer flange stays in place.
‹› The colored mark - C - is the largest radial run-out on the flange (corresponds to the greatest distance from the rotational axis).
-
2 Install the M8 x 30 bolts - arrows - in the flange.
