A8L Quattro Sedan V8-4.2L (BVJ) (2007)
CV joint and boots must be free of grease.
1
Circlip (snap ring), must be replaced.
-
Position the CV joint boot between the - arrows -.
-
Apply 70 grams of joint grease to the inside of the CV joint.
-
Screw the old drive axle bolt into the CV joint as shown in the illustration.
-
Drive the CV joint onto the axle shaft with a plastic hammer until the circlip engages.
-
Insert 50 grams of drive axle grease into the CV joint on the boot side.
Outer CV Joint Clamp, Installing
-
Install the clamp onto the outer CV joint.