A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Disconnect coolant hoses at coolant pipe - arrows -.
‹› Shown from rear to improve clarity.
-
Remove coolant pipe.
Installing
Installation is in reverse order of removal, note the following:
‹› Replace seals and O-rings.
‹› Secure all hose connections using hose clamps appropriate for the model type.
‹› During installation, all cable ties must be re-installed at the same location.
-
Install strut tower brace.
-
Install and adjust wiper arms
-
Install intake manifold lower-part => [ Intake Manifold Lower-Section ] See: Engine/Intake Manifold/Service and Repair/Intake Manifold
Lower-Section.
-
Install intake manifold upper-part => [ Intake Manifold Upper Section ] See: Engine/Intake Manifold/Service and Repair/Intake Manifold Upper
Section/Cylinder Head, Valvetrain.
-
Fill with coolant => [ Filling ] See: Service and Repair/Procedures.
Tightening Specifications