Cabriolet V6-2.8L (AFC) (1995)
-
Position hydraulic hoses and electrical wiring on hydraulic cylinder -2- as shown and secure with tie wraps -1-.
Note:
Support ring -3- is intended to prevent kinking.
-
Pull hydraulic hose with red marking through as far as tie wrap on bracket (arrow).
-
Install tie wrap over red marking (arrow).
-
Install hydraulic hoses with connection fittings through connecting plate.
-
Install sleeve -1- of special tool 3335 over connection fitting, push retaining ring -2- over sleeve and push in using special tool -3- until properly
seated.
CAUTION: Retaining rings -2- must be pushed all the way over the collar on connection fitting -1-.