RS 4 Quattro Cabriolet V8-42L (BNS) (2008) C-Pillar Trim Replacement
/Page-3324002.png)
‹› Removal:
-
Remove luggage compartment floor mat. Refer to => [ Luggage Compartment Liner ] See: Luggage Compartment Liner.
-
Remove rear cross panel trim. Refer to => [ Rear Cross Panel Trim ] See: Rear Cross Panel Trim.
-
Remove rear seat backrest. Refer to => [ Rear Seat Backrest, Fixed ] See: Seats/Service and Repair/Removal and Replacement/Rear Seats.
-
Position tie-downs - 5 - upward (1x or Qty. 2, depending on version).
-
Remove two Phillips-head screws - 6 - in tie-downs.
-
Unclip the clip - 3 -.
-
Disengage clip - 3 - from tab.
-
Disengage three clips - 4 -.
-
If necessary, remove cover - 2 -.
-
Pull off luggage compartment trim - 1 - upward.
‹› Installing:
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
-
After installation has been completed, pull tailgate rubber over trim - 1 -.
2
Cover
3
Clip
4
Clips (Qty. 3)
5
Tie-down
6
Screws, (Qty. 2)
‹› Tightening specification 4 Nm
