RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Belt/Service and Repair.
-
Thread belt - 3 - out of belt height adjuster - 4 -.
‹› Installing:
CAUTION!
Always follow installation sequence for B-pillar trim.
‹› Button - 6 - must not be pressed during installation.
-
Thread belt - 3 - into belt height adjuster - 4 -.
-
Install belt height adjuster - 4 -. Refer to => [ Installing Upper B Pillar Trim In Belt Height Adjuster ].
-
Clip B-pillar trim in at upper edge. Ensure that the two tabs - 5 - and two retainers - 7 - engage correctly (gap width must fit).
-
Clip clips - 2 - to lower edge of upper B-pillar trim - 1 -.
CAUTION!
Ensure trim is held securely.
‹› Function test after installing trim:
‹› Belt height adjuster must audibly engage into all five possible positions (even top position).
‹› Button must return by itself to upper position after being actuated.
2
Clamps (Qty. 2)
3
Belt Webbing
4
Seat Belt Height Adjuster
5
Tabs (Qty. 2)
6
Height Adjustment Button
7
Tabs (Qty. 2)
Installing Upper B Pillar Trim In Belt Height Adjuster