RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-3623001.png)
Convertible Top Position Sensor / Switch: Service and Repair
Convertible Top Locking Motor V223 / Lock Switch (Open) F294 / Lock Switch (Closed) F295
Removing and Installing
Convertible Top Locking Motor V223 / Convertible Top Lock Switch (Open) F294 / Convertible Top Lock Switch (Closed) F295, Removing
and Installing
Removing
-
Store convertible top in convertible top compartment.
-
The convertible top compartment cover remains open.
-
Remove front roof frame seal bolts.
-
Carefully remove front rail trim.
-
Remove ball joint wire fastener and press push rods from convertible top lock ball studs.
-
Disconnect electrical connector.
-
Mark exact position of convertible top latch on rail 1.
-
Remove convertible top latch bolts and remove latch.
Installing
-
Ensure convertible top latch is installed in the position marked earlier.
-
Further installation is performed in the reverse order of removal.
-
Adjust convertible top latch.
