RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Accessory Drive: Service and Repair
Power Take-Off Drive Chain
Power Take-Off Drive Chain
Special tools, testers and auxiliary items required
‹› Locking Pin (3242)
‹› Locking Pin (T40071)
Removing
‹› Engine and transmission separated. Refer to => [ Engine and Transmission, Separating ] See: Service and Repair/Removal and
Replacement/Engine and Transmission, Separating, engine on the Scissor Lift Platform (VAS 6131 A) or secured by the engine/transmission
holder, refer to => [ Engine, Securing to Engine and Transmission Holder ] See: Service and Repair/Removal and Replacement/Engine, Securing
to Engine and Transmission Holder.
‹› Engine oil drained.
-
Remove clutch pressure plate.
-
Remove dual-mass flywheel. Refer to => [ Dual Mass Flywheel ] See: Transmission and Drivetrain/Flywheel/Service and Repair/Dual Mass
Flywheel.
-
Remove left and right timing chain covers. Refer to => [ Left and Right Timing Chain Covers ] See: Timing Components/Timing Cover/Service
and Repair/Left and Right Timing Chain Covers.
-
Remove intake manifold.
-
Remove oil filter housing. Refer to => [ Oil Filter Housing ] See: Engine Lubrication/Oil Cooler/Service and Repair/Oil Filter Housing.
-
Remove lower timing chain cover. Refer to => [ Lower Timing Chain Cover ] See: Timing Components/Timing Cover/Service and Repair/Lower
Timing Chain Cover.
-
Mark running direction of power take-off chain with paint.