RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Install M10 x 100 bolt - 3 - into rear final drive.
-
To loosen bolts - 1 - of the driveshaft, counter hold with an assembly lever - 2 -.
-
Remove bolts at the front Constant Velocity (CV) joint, detach the driveshaft and support it using engine and transmission jack (VAG1383A).
-
Remove bolts at rear CV joint and detach driveshaft.
‹› Only transport and store driveshaft when extended.
Installing
Installation is carried out in reverse order. Note the following:
‹› To avoid imbalance, the flanges of the driveshaft - arrow A - and of the rear final drive - arrow B - must be installed so that the factory color
markings or the markings made subsequently are in line.