RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1518003.png)
‹› Checking, refer to => [ Inner Constant Velocity Joint, 100 mm, Checking ] See: Testing and Inspection/Front Suspension/Inner Constant
Velocity Joint, 100 mm, Checking
‹› When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
11 - Backing plate
12 - Socket head bolt
13 - Protective boot with cap
8GIn case of damage, check inner CV joint => [ Inner Constant Velocity Joint, 100 mm, Checking ] See: Testing and Inspection/Front Suspension/Inner
Constant Velocity Joint, 100 mm, Checking
‹› Check for tears and scuffing
‹› Replace only as complete unit
‹› Removing => [ Inner CV joint, removing ] See: Inner Constant Velocity Joint, 100 mm, ServicingCV
‹› Installing => [ Inner CV joint, installing ] See: Inner Constant Velocity Joint, 100 mm, ServicingCV
‹› Protective boot-drive axle sealing surfaces and cap must be free of grease when installing
