RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Remove circlip before pressing out flange shaft.
Pressing in flange shaft
-
Before pressing in flange shaft, tighten damper.
‹› If a sealing ring is installed with additional dust lip, refer to => [ Differentiation of sealing rings ] , a flange shaft must be installed with a groove,
refer to => [ As of serial number 42987 - Flange shaft with nut and sealing ring with additional dust lip ] Allocate components via the.
-
Install securing ring.
As of serial number 42987 - Flange shaft with nut - arrow A - and sealing ring with additional dust lip - arrow B -