RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-100001.png)
Headlamp Alignment Control Module: Service and Repair
High Intensity Gas Discharge (HID) Lamp Control Module J343 / J344, Removing and Installing
High Intensity Gas Discharge (HID) Lamp Control Module J343 / J344, Removing And Installing
CAUTION:
-
HIGH VOLTAGE.
-
Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH
VOLTAGE" warning symbols.
Removing
-
Remove headlamp.
-
Remove screws - arrows - .
-
Remove control module - 1 - from headlamp housing.
-
Disconnect adapter cable - 2 - for HID headlamp bulb at control module - 1 -.
Installing
Install in reverse order of removal, noting the following:
-
Check gasket between control module for HID headlamp bulb and headlamp housing.
-
Install headlamp.
