RS 4 Quattro Sedan V8-4.2L (BNS) (2007)
/Page-1670005.png)
-
To tighten bolts - 1 - for the driveshaft, counter hold with an assembly lever - 2 -.
-
Remove assembly device (3139)
-
Remove bolts - arrows - for the center bearing. The driveshaft must be supported manually by a second mechanic.
‹› When removing the bolts support the driveshaft by hand. Refer to => [ Driveshaft Assembly Overview ] See: Driveshaft Assembly Overview.
-
Install heat shield - 2 -. Continue supporting driveshaft.
-
Install bolts - 4 - for center bearing several turns.
