S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
-
Pull plastic securing spring - 2 - slightly to front and push pin - 3 - upward only as far as necessary - arrow -.
‹› Make sure that pin is not pushed fully out.
-
Remove selector lever cable - 4 - from shift mechanism function unit.
‹› Take care not to bend or kink selector lever cable.
-
Remove nuts - arrows -.
‹› A second technician is required when detaching shift mechanism below vehicle.
‹› If the clips - 1 - or - 2 - break during removal, then the selector mechanism must be replaced. If a broken part falls into the shift mechanism, it will
jam up the mechanism.
-
Press holder clips - 1 - and - 2 - inward, at the same time pushing shift mechanism downward.
Installing
Install in reverse order, paying attention to the following:
‹› Tightening specifications. Refer to => [ Shift Mechanism Assembly Overview ] See: Shift Mechanism Assembly Overview
-
Install selector lever cable. Refer to => [ Selector Lever Cable and Locking Cable Assembly Overview ] See: Selector Lever Cable and Locking
Cable Assembly Overview.
-
Install new securing clasp - 1 - for selector lever cable to shift mechanism.