S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
9
Retaining clip
10
Bolt, 40 Nm
11
Push rod
‹› with screw and washers
12
Internal hex bolt - 23 Nm
13
Washer
14
Shift lever support
‹› Removing and installing => [ Selector Mechanism ] See: Selector Mechanism
15
Boot tensioning ring
16
Boot
‹› when removing, carefully remove from selector and push rod
‹› when installing, place on markings on selector rod and push rod
17
Internal hex bolt - 23 Nm
18
Clamping piece
19
Selector rod
20
Selector rod/shift lever CV joint
21
Nut - 10 Nm
22
Ball pin