S6 V8-4.2L (BBD) (2004)
/Page-2804002.png)
13. Spacer sleeve
^
Height: 8 mm
14. Inner oil line
^
Replace
15. O-ring
^
Always replace
16. Speedometer Vehicle Speed Sensor -G22-
17. O-ring
^
Always replace
^
Coat with Vaseline
18. Multi-Function Transmission Range Switch -F125-
^
Replacing seal for shift rod
19. Bolt - 8 Nm (70 inch lbs.)
20. O-ring
^
Always replace
21. Securing clip
22. Wiring harness
^
Transmission Fluid Temperature Sensor -G93- integrated in wiring harness
^
To replace, remove and install valve body.
^
Release from bracket for wiring harness -item 10-
^
Installation position of wiring harness connector: flat point of rear shoulder faces oil pan, the lugs on the shoulder are horizontal
23. Bolt - 9 Nm
24. Transmission Input Speed Sensor -GI82-
25. Spacer sleeve
^
Is connected in wiring harness in transmission.
^
Must be disconnected before removing valve body.
26. Screw - 6 Nm (53 inch lbs.)
27. Bracket
^
For solenoid valve
28. Solenoid Valve 4 -N91-
^
With O-ring
^
To replace, remove and install valve body
29. Solenoid Valve 3 -N90
^
Without O-ring
^
To replace, remove and install oil pan
30. Solenoid Valve 2 -N89-
^
Without O-ring
^
To replace, remove and install oil pan
31. Screw - 6 Nm (53 inch lbs.)
32. Bracket
^
For solenoid valve
33. Solenoid Valve 6 -N93-
^
With O-ring
^
To replace, remove and install oil pan
34. Solenoid Valve 7 -N94-
^
With O-ring
^
To replace, remove and install oil pan
35. Solenoid Valve 5 -N92-
^
With O-ring
^
To replace, remove and install oil pan
36. Solenoid Valve 1 -N88-
^
Without O-ring
^
To replace, remove and install oil pan and unbolt guide plate for park lock mechanism
^
When installing, do not tighten bolts for guide plate (23 Nm) when selector lever is in position "P"
37. Bolt - 6 Nm (53 inch lbs.)
38. Magnet
^
4 magnets in the beads of oil pan
39. O-ring
^
Always replace
40. ATF filler plug - 80 Nm (59 ft. lbs.)
^
17 mm hex socket
