S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
/Page-2083002.png)
2-Pin Connector
-
Connect US 1115 LED tester or equivalent (using VW 1594 connector test kit) to terminal 1 of connector, and to engine Ground (GND).
-
Operate starter for a few seconds.
^
LED tester must light up, during starter operation.
If NO:
-
Verify that circuit breakers -S72- and -S75- are OK.
2-Pin Connector
-
Check continuity between connector terminal 1 of wastegate bypass regulator valve, and EVAP frequency valve circuit breaker -S75- using
wiring diagram.
^
Must be 0.5 ohm maximum.
Central Electric Panel With Detail Of Relay Position 6
-
Check continuity between EVAP frequency valve circuit breaker -S75-, and terminal 31 of fuel pump relay -J17-, relay position 10, using
wiring diagram.
^
Must be 0.5 ohm maximum.
-
Check control signal to fuel pump relay.
