TT Quattro Coupe V6-3.2L (CBRA) (2008)
Seat Heater: Service and Repair
Seat Heating Element, Removing and Installing
Seat Heating Element, Removing And Installing
Removing
-
Remove cover and upholstery from seat pan.
-
Disconnect cover from upholstery.
-
Cut wire - 2 - off of old heating element - 3 -.
NOTE: The old seat heating element remains on the upholstery - 1 - and the new seat heating element is bonded over it.
Installing
-
Align new seat heating element - 3 - on upholstery - 1 -.
-
Remove protective foil and bond new seat heating element - 3 - to upholstery - 1 - and the old seat heating element.
CAUTION: Ensure the new seat heating element is bonded so it lines up with the old one.
-
Route connecting wires at locations - 4 - in bottom of gaps, avoiding crossover.
Further installation is performed in the reverse order of removal.