TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-3144004.png)
^
Install wire for pad wear indicator under dust cap -3- on bleeder valve and in retainer -2- on upper cap.
^
Attach connector -1- for pad wear indicator.
^
Locate retaining spring at top of brake carrier. Press top of retaining spring in direction -B-, and at the same time hold bottom of spring by exerting
pressure in the opposite direction -A-. Now push retaining spring into bore in brake caliper.
^
Locate retaining spring at bottom of brake carrier. Then press retaining spring in direction -A- first, hold in this position and at the same time press
into bore in brake caliper.
^
Installing wheels, tightening torque: 120 Nm
Note:
^
After changing brake pads, press brake pedal firmly several times with vehicle stationary to ensure that pads become properly seated.
^
Check brake fluid level after changing brake pads.
