TT Roadster L4-2.0L Turbo (BPY) (2008)
/Page-2302002.png)
-
Remove cover - B -.
-
Remove nuts - C - (tightening torque 3.5 Nm).
-
Remove cover grille - D -.
Installation is done is reverse order, observe the following:
NOTE:
-
Before installing, check seal bonded to bottom of cover grille for damage and replace if necessary. This seal prevents water from running under the
intake grille and into the A/C unit air intake shroud.
-
Ensure cover grille - D - is properly seated, water may flow into intake housing of A/C unit if cover grille is not installed correctly.
