1 Series E81 130i (N52K) 3-door
33 10 010
Removing and installing/replacing rear
differential
Special tools required:
•
33 4 420
Important!
Use only approved rear differential oils!
Note:
The following sequence was created using the E87 with N45 as
an example. Differences in detail (e.g. due to vibration damper) in
other engines are possible.
Necessary preliminary tasks:
•
Remove propeller shaft from rear differential
•
Remove output shaft from rear differential at both ends and
tie back
Important!
Observe gap between special tool 33 4 420 and dust
plates.
To avoid grinding noises, make sure the dust plates are not
damaged (e.g. bent).
Support rear differential with workshop jack and special tool
33 4 420 .
Release screws (1).
Release nut (2) and remove screw towards rear.
RA Removing and installing/replacing rear differential
BMW AG - TIS
22.01.2013 05:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
