bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

6 RA Removing And Installing_replacing Roofliner For Glass Slide_tilt Sunroof|Page 1979 > < 5 RA Replacing Seal For Glass Slide_tilt Sunroof Lid
Page 1
background image

54 12 136

Removing and installing/replacing roofliner
for glass slide/tilt sunroof

Necessary preliminary tasks:

Remove rain gutter

Note:

Carriage of rain gutter must not be situated in area of floating
roofliner.

Slightly raise spring stops (1) of slide housings with screwdriver.

Slides can now be pressed back fully against the springs.

Lift front and rear slides in succession out of guide rail:

Press roofliner (1) into opposite guide rail (spring-mounted).

At the same time press slide (2) with a screwdriver (3) or

similar against the spring.

Lift slide (2) out of guide rail.

Installation:

Make sure springs are installed in correct position.

Installation:

Slide stop spring (2) into guide rail (1) with flat plastic wedge
forwards up to drive cable (3).

RA  Removing and installing/replacing roofliner for glass slide/tilt sunroof

BMW AG - TIS

22.01.2013  08:30

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

6 RA Removing And Installing_replacing Roofliner For Glass Slide_tilt Sunroof|Page 1979 > < 5 RA Replacing Seal For Glass Slide_tilt Sunroof Lid