3 Series E36 318is (M44) SAL
Installation:
Check cylinder-head-cover seal and replace if necessary.
Pre-install cylinder-head-cover seal at cylinder head cover.
Installation:
Clean gasket residue from sealing surfaces.
Coat contact surfaces of joint with Drei Bond 1209 (refer
to BMW Parts Service).
Installation:
Clean gasket residue from sealing surfaces.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Caution!
The oil feed of the spray lead is sealed with a sealing ring.
Check/replace sealing ring.
Preassemble the sealing ring to the oil feed.
RA Removing and installing/sealing cylinder head cover (M44)
BMW AG - TIS
06.02.2013 17:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -