3 Series E36 318tds (M41) SAL
Drive in radial seal (1) with special tool 23 2 430.
Note:
Use plastic hammer to drive in.
Install guide tube.
Install screws with Loctite 243 screw locking varnish.
Tightening torque,
refer to Technical Data 23 11 2AZ.
Secure reverse gear shaft in front case section.
Install screw (1) with Loctite 243 screw locking varnish and
tighten.
Tightening torque,
refer to Technical Data 23 11 6AZ.
Loosen screw (2) from special tool 23 2 190.
Remove front case section and gear train from special tool
23 2 190 and place to one side with output end pointing
upwards.
RA Removing and installing/replacing complete input and output shafts (S5D 200G/ E3
BMW AG - TIS
06.02.2013 22:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -