3 Series E36 318tds (M41) SAL
Produce reinforcement plate for C-pillar and fit in.
Width = approx. 60 mm
Drill holes for plug welding.
Clean welding surfaces.
Slide reinforcement plate into remaining C-pillar section approx.
30 mm deep.
Plug weld.
Grind down welded surfaces.
Produce reinforcement plate for entrance joint and fit in.
Width = approx. 60 mm
Drill holes in C-pillar for plug welding of the reinforcement plate.
RA Replacing outer section of left or right rear wheel housing (side panel removed)
BMW AG - TIS
07.02.2013 01:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
