3 Series E36 318ti (M44) COMP
41 62 014
Adjusting trunk lid to fit (compact)
Note:
Engine hood was fitted and screwed in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Remove left and right finisher strip.
Caution!
Do not damage paintwork.
For removal, insert appropriate screwdriver (1) in one of the
slots (2) and turn slightly.
Pull finisher forwards to remove.
Unscrew detent buffers from left and right sides of trunk lid.
Check fulcrum pads on lower section of trunk lid lock for damage
and replace if necessary.
Loosen screws on lower section of trunk lid lock until it can just be
moved, enabling it to center itself.
The lower section of the trunk lid lock must not scrape against the
upper section.
RA Adjusting trunk lid to fit (compact)
BMW AG - TIS
07.02.2013 03:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -